Electronics Assembler how-to
How to Build a Wire Harness from a Drawing
Harnesses must match drawings exactly.
Quick answer
Harnesses must match drawings exactly. In short: cut; strip; insert, then complete the remaining steps below.
Step by step
Cut wires to length.
Strip and crimp.
Insert into connectors.
Lay out on the board.
Tie and label.
Test continuity.
Safety reminders for electronics assemblers
- Ventilate soldering fumes
- Use ESD protection
- Wear eye protection
- Prevent burns
Key terms
PCB · Through-hole · SMT · Solder joint · Flux · Cold joint: see the full electronics assembler glossary.