Foundry Moldmaker how-to
How to Set a Core in a Mold
Cores form internal shapes.
Quick answer
Cores form internal shapes. In short: inspect; clean; set, then complete the remaining steps below.
Step by step
Inspect the core.
Clean core prints.
Set carefully.
Check position.
Add chaplets if needed.
Close the mold.
Safety reminders for foundry moldmakers
- Wear respirators for silica
- Lift safely
- Use hoists
- Follow foundry safety rules
Key terms
Flask · Ramming · Green sand · No-bake sand · Core print · Vent: see the full foundry moldmaker glossary.